AEG Electrolux KAM 2 automatic Serie Mode D'emploi page 18

822_949_330 KAM200.book Seite 18 Donnerstag, 17. Januar 2008 9:49 21
g
0 Press button
The grinding procedure will start auto-
matically at the set time. At the start
time the green indicator for
button
AUTO
indicator next to the button
(Figure 2/B) will be illuminated. Once
the coffee has been ground, the water
supply swings back automatically to
the brewing position and brewing be-
gins.
As long as the red indicator next to
3
button
button
If, once pre-programmed, the start
3
time, number of cups and coffee
strength are not to be changed you
need only press the
activate the „Auto" function.
6 Preparing coffee in
advance of your setting
If the appliance is pre-programmed
using the "Auto" function (the green
indicator for the
minated to indicate „Auto" function
activated), but you would like some
coffee before the start time, then you
must switch off the „Auto" function
with the button
The green lamp goes out. Start coffee
preparation in normal mode with the
button
and brewing will begin at once.
Note when preparing coffee with
1
beans: Coffee preparation takes place
with the settings in normal mode
(number of cups, coffee strength).
When these differ from the settings for
the „Auto" function, you must change
the settings accordingly in the normal
mode prior to the start!
7 Deactivating the "Auto"
function
If you have activated the "Auto" func-
tion but do not want the programme
18
(Figure 2/F).
AUTO
will go out and the red
8
9
(Bild 2/B) is on, only the
will work.
10
button to
AUTO
11
button is illu-
AUTO
(Figure 2/F).
AUTO
(Figure 2/B). Grinding
to start, simply press the
ton (Figure 2/F). The green indicator
will go off.
Switching off
Switch the appliance off with the
button (Figure 2/B).
Warming plate (Figure 1/M)
After brewing the warming plate keeps
the coffee in the glass jug warm. Two
hours after brewing the appliance
switches off automatically.
Removing the jug
(Figure 15)
When the jug is removed, the anti-drip
valve prevents dripping.
Cleaning
(It is imperative that these
instructions are observed!)
11.1 Coffee part
The filter insert can be removed for
emptying and cleaning.
0 Swing out the swivel filter.
0 Place your finger in the rear handle
recess (Figure 16) and pull the bracket
up.
This unlocks the filter insert and it can
be removed for cleaning.
0 Activate the anti-drip valve several
times during cleaning.
0 After cleaning the filter insert, fit the
swivel filter. Reposition the bracket
(Figure 17).
The filter insert is now relocked. Please
check that it is positioned and locked
correctly!
0 Only clean the appliance using a damp
cloth; never immerse it in water. Only
the coffee jug and jug lid are dish-
washer safe.
but-
AUTO