Roco BR 85 Manuel page 25

Please note! To achieve proper mounting of the enclosed etched labels will you plea-
se follow these instructions:
As delivered the etched label
surface is completely covered
with paint. To make the metal
numbers and letters visible the
paint must be removed from the
actual letter and numeral surfa-
ces: this is done as follows:
1. Before removing the labels from the etched frame place them with their backs on a firm and
completely level surface.
2. Remove the paint from the surface of the characters carefully either with the ROCO rubber
(art. no. 10002) a sharp knife having a straight edge or similar
object (e.g. single-edge razor blade). Take care that while doing this the paint surface bet-
ween the characters is not damaged.
3. If the result is not satisfactory it is recommended that the remaining paint is removed with
a suitable paint remover. Thoroughly dry the labels and then
reapply fresh paint. Repeat the removal of the paint from the surface of the characters after
the new paint is completely dry.
4. Carefully extract the different labels from their etching frames and remove any remaining
burrs.
5. Attach the etched labels with very small amounts of adhesive on top of the printed signs on
the vehicle.
Cement
8072264920.indd 25
Working with etched Labels
W M 80 W M 80
20.03.2018 14:43:27
25
25