EV CHECK
Before Use
5.
5-1.Standard Equipment
The following equipment and accessories are included in the package, before using the unit,make sure that all
items are included.
• Main Unit x 1
• Type 2 Test Cable x 1
• Portable Package x 1
• Instruction Manual x 1 (This document)
5-2.Optional Accessories
Type 1 Test Cable for EV charging station cable type 1 with fixed cable and vehicle connector which fits to all
versions of the test adapter.
5-3.Safety Measures
• The test adapter has been built and tested in compliance with the valid safety regulations and left the factory in
safe and perfect condition.
• In order to maintain this condition and to ensure safe instrument operation , the user must pay attention to the
references and warnings contained within this user manual.
WARNING, DANGER OF ELECTRICAL SHOCK
• In order to avoid electrical shock, valid safety and national regulations regarding excessive contact voltages must
receive utmost attention when working with voltages exceeding 120V DC or 50V RMS AC.
• The respective accident prevention regulations established by the national health & safety board for electrical
systems and equipment must be strictly met at all times.
• Prior to any operation, ensure that the adapter and cable assemblies are in perfect condition.
• The adapter may only be connected to charging stations as indicated in the technical specification section.
• The adapter may only be used within the operating ranges as specified in the technical specification section.
• The adapter may only be used in dry and clean environments, dirt and humidity reduce insulation resistance and
may lead to electrical shocks, particularly for high voltages.
• Never use the adapter in precipitation (e.g., dew or rain), in case of condensation due to temperature jumps, the
adapter may not be used.
• Perfect tests and measurements may only be ensured within the temperature range of 0 to 40°C.
• If the operator's safety is no longer guaranteed, remove the adapter from service and protect against use.
• To ensure a safe measurement only use original cable assemblies.
• If the operator's safety is no longer guaranteed, remove the adapter from service and protect against use.
• Safety can no longer be guaranteed if the adapter (or cable assemblies):
Show obvious damage.
Do not carry out the desired tests or measurements.
Have been stored for too long under unfavorable conditions.
Have been subjected to mechanical stress during transport.
24