Watts Electronics Vision WiFi Manuel D'utilisateur Et D'installation page 3

1 INSTALL YOUR CENTRAL
a- Wall mounting
.
1- Connect the power as described below :
NOT TO BE USED
MAINS POWER SUPPLY 85-265VAC - 50/60HZ
2- Screw the power unit on the wall and connect to power
supply. Note! The tab must be on the top!
3- Put the switch on ON position
ON/OFF
4- Mount the Central control on the power unit and slide it on the
bottom to clip it. The Central is ready for operation.
b- Table installation (with optional mini USB cable
– sold seperately)
CABLE
ON/OFF
Connect the central unit with the mini USB cable (5V, 1A) and
then mount the leg support on it and put the switch on ON
position. The central unit is ready for operation.
MAIN SCREEN ICONS
3
10
7
5
① Date
② Display the time or the ambient T° of the room or zone. Make
your choice by pressing on the central part of the screen
③ Outside sensor temperature
④ Screen lock. Long press toggles between locking / unlocking.
⑤ Error flag – press to access RF, limits, alarms, battery
anomalies.
⑥ The device is working on battery (! only for settings and
pairing).
⑦ Rooms access (if Central is locked - cannot change settings).
⑧ Main menu.
⑨ Holidays mode status.
⑩ Boiler status displayed if connected to the Central.
⑪ Display the ambient temperature in one room
GENERAL PICTOGRAMS
2 ADJUST TIME / USER SETTINGS

Set the time and the date manualy or automatically. If you select
auto, you have to set the time zone (UTC) and the device is
getting the time from internet (WIFI connection is mandatory).

Set your language - see MAIN MENU section

Personalise your screen settings, eg background colour etc
See "User Settings Menu" in MAIN MENU section (page 8) for
further information.
3
1
9
2
6
To return to the main screen.
To return to the previous screen.
The buttons with a red point need a long
press (min 5s).
11
4
8