Publicité
Les langues disponibles
Les langues disponibles
CONNECTIONS
Ducted mode air exhaust system
Caution: To reduce the risk of fire, use metal ductwork is preferred.
1.
Decide where the ductwork will run between the hood and the
outside.
2.
A straight, short duct run will allow the hood to perform most
efficiently.
3.
Long duct runs, elbows, and transitions will reduce the
performance of the hood. Use as few of them as possible.
Larger ducting may be required for best performance with
longer duct runs.
4.
Attach an adequate length of φ 6" round duct to the air outlet adapter.
5.
The air must not be discharge into a flue that is used for exhausting fumes from appliances
burning gas or other fuels" "Regulations concerning the discharge of air have to be fulfilled.
6.
Install a roof/wall cap. Connect round metal ductwork to cap and work back towards hood location.
Use duct tape to seal the joints between ductwork sections.
The regular vent of this range hood is top vent,customer can choose rear vent as per below steps:
1.
Remove motor from top of body by four screws.
2.
Remove square metal plate from back of body by four screws
Publicité
