Replace The Cutting Line; Replace The Bump Knob; Assemble The Trimmer Head; Remove The Trimmer Head - GreenWorks STE456 Manuel D'opérateur

NOTE
Make sure that the cutting line is in the slot on the new
spool, and is extended approximately 15 cm before
you install the new spool.
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Install the spool and spool cover onto the trimmer
head.
8. Push the spool cover until it clicks into position.

10.4 REPLACE THE CUTTING LINE

Figure 16 - 18.
NOTE
Remove the remaining cutting line on the spool.
NOTE
Use only with the nylon cutting line of 0.08" (2 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into
the slot in the center rim of the spool. Make sure
that the line snaps into position in the slot.
3. With your finger between the lines, wind the lines
equally and tightly around the spool in the indicated
direction.
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.

10.5 REPLACE THE BUMP KNOB

Figure 19 - 20.
1. Push the tabs on the sides of the trimmer head at
the same time.
2. Pull and remove the spool cover.
3. Remove the spool.
4. Hold the bump knob and pry it out with a metal rod
(not provided).
5. Put the new bump knob into the spool housing.

10.6 ASSEMBLE THE TRIMMER HEAD

Figure 21
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
English
You must install the cut-off blade when you use the
trimmer head.

10.7 REMOVE THE TRIMMER HEAD

Figure 21
1. Put the metal rod in the specified angle transmission
hole to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
11 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.

11.1 STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
12

TROUBLESHOOTING

Problem Possible Cause
The ma- No electrical
chine does contact between
not start the machine and
when you the battery pack.
push the
trigger.
The battery pack
is depleted.
The lock-out but-
ton and trigger
are not pushed
at the same
time.
7
IMPORTANT
WARNING
Solution
1. Remove battery
pack.
2. Check contact and
install the battery pack
again.
Charge the battery
pack.
1. Pull the lock-out but-
ton and hold it.
2. Pull the trigger to
start the machine.
EN