Clean The Machine; Replace The Spool; Replace The Cutting Line; Transportation And Storage - GreenWorks ST24B210 Manuel De L'utilisateur

EN
• Use correct clothing, protective gloves and safety
glasses.
9.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth
dipped in neutral detergent.
• Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or
excessive grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
9.3

REPLACE THE SPOOL

1. Push the tabs （20） on the sides of the trimmer
head at the same time.
2. Pull and remove the spool cover （19）.
3. Remove the spool (21).
4. Replace with a new spool.
Make sure that the cutting line is in the guide slot on
the new spool, and is extended approximately 5 in.
before you install the new spool.
5. Put the end of the cutting line through the eyelet
(23).
6. Extend the cutting line to release it from the guide
slot in the spool.
7. Push the tabs and install the spool cover onto the
spool housing (22).
8. Push the spool cover until it clicks into position.
NOTE
English
9.4

REPLACE THE CUTTING LINE

Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.065" (1.65
mm) diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend one end of the line 1/4 of an inch (6.35mm) .
3. Insert the line into the anchor hole (24) of the spool.
4. Wind the cutting line around the spool tightly in the
indicated direction.
5. Put the cutting line in the guide slot (25).
6. Do not wind the cutting line beyond the edge of the
spool.
10 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.

10.1 MOVE THE MACHINE

When you move the machine, you must:
8
NOTE
NOTE
WARNING