Whittier Wood Products 702W Manuel D'instructions page 2

BEFORE BEGINNING ASSEMBLY, check that the quantities of the parts received match those on
PART DESCRIPTION
A1 Single Door . . . . . . . . . . . . – . . . – . . . 1
A2 Double Door . . . . . . . . . . . 2 . . . 2 . . . 2
B Hinge . . . . . . . . . . . . . . . . . 4 . . . 4 . . . 6
C #5x5/8" Brass Screw . . . 20 . . 20 . . 30
DD Door Knob Kit . . . . . . . . . . 2 . . . 2 . . . 3
E #8x1" Machine Screw . . . . 2 . . . 2 . . . 3
ASSEMBLY INSTRUCTIONS
We recommend finishing the doors before attaching to finished unit. Before finishing,
NOTE: Finish the doors using the same materials and methods that were
C
A
FIG. 1
1) Lay the Doors (A) face down on a clean protected surface. Place the Hinge (B) against the back of
each door so the outer hole in the hinge is over the predrilled hole in the door. Attach the hinges to
the doors using #5x5/8" Flat Head Brass Screws (C) through all three holes in the back of each
hinge. See FIGURE 1.
Attach the Door Knobs (DD) using #8x1" Machine Screws (E). See FIGURE 2.
NOTE: 703W — Discard the screws in the knob kits. Use the Star Washer as shown in Fig. 2.
702W — The doors have four holes punched for hinge location. When attaching the hinges,
use the two holes closest to the center of the door. See FIGURE 2a.
702W, 703W, 706W Door Kits
the parts list below.
QTY QTY QTY
702 703
TOOLS REQUIRED: Phillips Head Screwdriver.
IMPORTANT:
read enclosed finishing hints.
used to finish the unit.
B
FIG. 2
PART DESCRIPTION
706
F Door Stop . . . . . . . . . . . . . 1 . . . – . . . 2
G #8x1¼" Pan Head Screw . 2 . . . – . . . 4
H Door Pad . . . . . . . . . . . . . . 2 . . . – . . . 3
I Veneer Spacer . . . . . . . . . 2 . . . 2 . . . 2
J Magnetic Catch Kit . . . . . . – . . . 2 . . . –
E
FOR 703W ONLY:
Insert Star Washer
QTY
702
DD
FOR 702W
QTY QTY
703 706
FIG. 2a