Whittier Wood Products 702W Manuel D'instructions page 4

3) Open the door and attach a Door Pad (H) to the back of each door where it touches the adjustable
shelf. If no adjustable shelf is used, see special note below.
FIG. 4
FOR 702W & 706W: (NOT FOR 703W)
NOTE: If no adjustable shelf is to be used behind the doors, a Door Stop (F) must be used. (For use
on the Entertainment Center, place one spacer behind the shelf facing. For use on the Wall Units
place two veneer spacers behind the center shelf facing.) Place Door Stop (F) against spacer(s) in
the middle of the opening where both doors will make contact. For the single door of the
Entertainment Center use the same procedure, only placing the spacer in the upper corner of the
side opposite the hinge. Attach door stop with #8x1¼" Pan Head Screws (G). See FIGURE 4.
Attach a Door Pad (H) to the back of each door where it touches the door stop.
FOR 703W ONLY:
Attach a Magnetic Catch (J) to each side of Lower Vertical Divider right below lower shelf and 3/4"
back from the front edge. Attach a catch plate to inside of each door where it will make contact with
a magnetic catch.
VENEER SPACER (I)
Two shown for wall unit installation.
F
G
703W