Publicité
Les langues disponibles
Les langues disponibles
SP 6500
G. Press
, the display shows the previous setting turn-on time by default. Press
continuously to set the turn-off time. Such as set the shutdown time at 13:00pm (the display as figure
e), (note: turn-off time later than turn-on time, when turn-on time same as turn-off time, the unit in
standby mode).
H. Repeat steps 4-7 above, you can set the whole weekly program (& each day, the work of each
segment opens, the time of shutdown).
I. After above setting, press
turn-on time of the day, then press "
press "
" to confirm the setting.
J. To cancel the weekly function, press the
unit will revert to the previous working status.
Note:
- After the above setting are completed and P program is working, for checking the program press
until take required day and pulse
turn-on time and TIME OFF to check turn-off time.
- The turn-on time periods 0~24hours, cannot set to minutes;
- The "time/off "cannot be less than "time/on";
- When the "time/on" is the same as "time/off", the time period enter into standby mode.
A
Note: if main switch off, power cut off or plug out, it needs reset. You can press
time/day.
7. Set open-window detection(only by remote control)：
A. Press
, the product enter into working status. Heating for a moment to stable.
B. Press
by remote control, light
to set target temperature. During open-window detection mode, once the room temperature drops
5-10ºC within 10 minutes, then the product will stop working within 30 minutes and enter into standby
mode. Turn on the unit, it need press
Turn off the open-window detection, press
working mode. How to operate, for example: current room temperature lower than 23ºC, setting 23℃,
open-window detection on (pic. F).
c. Open-window detection and weekly program can work simultaneously (pic. G). Heater will work
according the program and set temperature and if room temperature decrease 5-10ºC for 10 minutes
the appliance will stop and enter in standby mode.
chose the unit turn-on day of the week, then press
/
" to set desired temperature (temperature range 10-49℃),
, the light "p" will go off. The weekly program is off. The
to select the period you want to check and pulse TIME ON to check
B
C
/ºC light on; the temperature display "23" by default. Press
again.
again, the
D
to check you set
light off, the unit will resume to previous
to choose the
E
/
19
Publicité
