Orbegozo SP 6500 Manuel D'instructions page 16

SP 6500
2. Once press F, enter into fan mode, display shows like photo A; press F in second time, enter into lower
heating, display like photo B; press F in third time, enter into high heating, display like photo C, press in
fourth time, enter into in standby mode (fan keeps working for 30 seconds before shutting down
completely).
3. Turn-off timer. Press
time increases one hour for timer. After setting time, the display will show current setting time for 5
seconds, then resume to previous display, meanwhile the
setting 8h.
4. Turn-on timer. In standby mode, press
12 hours. After complete setting, the display shows the appointment turn-on time and also the light
is on. The display automatically decreases 1 hour for each hour passed. When the appointment power-
on time arrived, the product will automatically turns on. The default setting temperature is 23 ℃ during
appointment turn-on. Below photos is an example to set appointment turn-on time to 8 hours:
A
button to set timer (1-12hours) during working status. Pressing the button one
timer button, you can set the appointment turn-on time in 1-
B
light on. Below photo is an example of
C
16