Cleaning The Device; Restore Factory Settings; Troubleshooting; Disposal - brennenstuhl Brematic PRO RM 868 01 4211 Mode D'emploi

Wireless Smoke and Heat Alarm 868.3 MHz
Follow the on-screen instructions.
Press the test / learn button on the device three times in
succession within 2 seconds.
A tone will sound to confirm a successful pairing. If pairing fails,
the device LED continues to light up. Press the test / learn button
on the device again in order to turn off the device LED. If necessary,
repeat the pairing process again.
Enter a device name for the device, e.g. smoke alarm "living room".
Select "Add" to assign the device to the room.
First tap "Back" to leave the room, then "Done" to complete the
pairing process.
For more information about the app and how to use it, please visit
our homepage at: www.brematic.com/en/service.

Cleaning the device

The smoke alarm must be cleaned at least once a month.
Remove the battery before cleaning.
Clean the device with a dry, lint-free cloth. For tough dirt, you
may also dampen the cloth slightly.
Do not clean with solvent-based cleaners. These could damage
the device surface and markings.
Never immerse the device in water or other liquids. The device
may otherwise be damaged.
After cleaning, reinsert the battery and proceed by carrying out
a function test (see "Function test" section).

Restore factory settings

The device can be restored to the factory settings at any time.
Remove the batteries for 5 seconds.
Press and hold the test / learn button.
Insert the batteries.
Continue to hold down the test / learn button until the device
LED goes out. Release the test / learn button. The device LED is
switched on.
Press the test / learn button again.
An alarm tone will sound to confirm that the device was reset.
20 EN

Troubleshooting

Display Meaning
Persistent, pulsing Alarm or test
tone. function was
triggered.
Audible signal Low battery.
sounds every
50 seconds.
The signal tone The device is
sounds three times undergoing a
every 0.5 seconds. function test.

Disposal

The packaging is made from environmentally-friendly
materials which can be disposed of through your local
recycling facilities.
Contact your local refuse disposal authority for more details of how to
dispose of your worn-out product.
To help protect the environment, please dispose of the
product properly when it has reached the end of its
useful life, not in the household waste. Please contact
your municipality for information on collection facilities
and their opening hours.
Faulty or drained batteries must be recycled in accordance with Directive
2006/66/EC and its amendments. Return batteries and / or the device
to the available recycling facilities.
Improper disposal of batteries can
harm the environment!
Never dispose of batteries in your household waste. They may contain
toxic heavy metals and are subject to hazardous waste regulations.
The chemical symbols of the heavy metals are: Cd = cadmium, Hg =
mercury, Pb = lead. Therefore dispose of used batteries through your
local collection facilities.

Service

For questions related to the product, please contact us at
www.brematic.com/en/service.
Tel.: 0080048720743 (free of charge)
Solution
Immediately leave
the danger zone or
release the test button
(in the case of a
function test).
Replace the battery.
Release the test /
learn button to end
the function test.