Meec tools 016876 Mode D'emploi page 25

using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
Battery powered screwdriver for easy access
when assembling furniture. Provided with
integrated LED light, battery indicator, right/
left drive, adjustable body, soft grip surfaces,
magnetic bit holder and two 50 mm bits.
1. Magnetic bit holder
2. Bits
3. Battery charging indicator
4. Lock button for handle
5. Ventilation openings
6. LED light
7. Rotation selector
8. Power switch
9. Handle
10. USB charger cable
FIG. 1
USE
INTENDED USE
Battery powered screwdriver for easy access when
assembling furniture. Provided with integrated
LED light, battery indicator, right/left drive,
adjustable body, soft grip surfaces, magnetic bit
holder and two 50 mm bits.
CHARGING THE BATTERY
WARNING!
Make sure to do the charging in a suitable
place and to use the right charger. Never
connect an unknown charger, or a charger,
charging cord or battery that can be suspected
to be defective. Otherwise there is a risk of
overheating, and in the worst case fire. Do not
leave the battery unattended when charging.
1. Connect the battery charger cable to the
charger port.
FIG. 2
2. Plug the charger into a power point.
Check that the mains voltage corresponds
to the rated voltage on the type plate.
3. The charging time is affected by charge
status of the battery. It can take up to
10 hours to fully charge a new discharged
battery. If the charging takes too long this
points to a malfunction.
CHARGING INDICATOR
The battery charging indicator shows the
battery charge. Press the button(3) to show the
battery charge.
Green light = Charger connected to mains.
Red light = Battery charging in progress.
Green light = Battery fully charged.
FITTING BITS
1. The drive axle locks automatically when
the motor is switched off.
2. Put the required bit in the bit holder in the
chuck.
FIG. 3
3. Use the bit holder for work that involves
frequently changing bits. If the same bit
is used for a long time it is recommended
to remove the bit holder and lock the bit
directly in the chuck.
4. Remove the bit after use.
SCREW BITS
• Only use screw bits that fit the screw heads.
• Do not use damaged bits.
EN
25