Phocos CIS-CU Manuel De L'utilisateur page 16

Buzzer Response
After transmitting
After transmitting
While pressing Test or Send button
After pressing button
After long-pressing Test or
Send button
LED Response
"Error" after "Transmit"
"Error" while "Transmit"
"Error"
"OK" after "Transmit"
"Transmit"
Push Buttons
Test
Send
Test pressed 4s
Send pressed 4s
1)
If pressing the button causes a load disconnect event (LVD/SOC,
over current) the load will be switched off.
2)
Be sure to program only one CIS at a time.
Battery Setting
There are four setting options for configuring the battery type. If the
"Send" button on the remote control is pressed briefly, a distinction
is made between lead-acid battery type GEL / AGM and flooded. If
lithium was previously set as the battery type, this has no effect.
To set the battery type to lithium, or to switch from lithium to battery
types lead-acid GEL / AGM or flooded, the "Send" button must be
held down for 4 seconds.
www.phocos.com
Programming error
Programming
successful
Begin transmission
CIS-CU battery empty
Long press recognized,
continued transmission
Programing error
Low battery
Battery empty
Programming successful
Transmitting
Load(s) on for >1 minute
Transmit all settings
Load(s) on for >1 minute and
transmission of base dimming ²
Transmit all settings except base
dimming level ²
1
2
1 5 | P a g e