Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
The device has two operating modes. It can be operated via DIP Switches or it can be run in DMX-controlled
mode.
After you connected the device to the mains, you can control the spots via your lighting controller.
OPERATION VIA DIP SWITCHES:
Manual Mode
Auto Mode
DMX-CONTROLLED OPERATION:
Audience Blinder 2 x PAR-36 DMX and Audience Blinder 4 x PAR-36 DMX
You can control the spots individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing
Each Audience Blinder 2 x PAR-36 DMX occupies 1 channel. To ensure that the control signals are
properly directed to each projector, the projector requires addressing. This is to be adjusted for every single
projector by changing the DIP-switches as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more projectors are
addressed similarly, they will work similarly.
Audience Blinder 2 X PAR-36 DMX
In order to select Manual Mode einzustellen, set DIP- switches 9 and
10 to ON.
The brightness of the two lamps can be adjusted be via DIP switches
5 to 8. DIP switches 1 to 4 are invalid.
In order to select Auto Mode, set DIP- switch 9 to OFF and 10 to ON.
The dimm speed of the lamps can be adjusted be via DIP switches 1
to 8. When DIP switches 1 to 8 are ON, the dimm speed is very slow;
when DIP switches 1 to 8 are OFF, the dimm speed is very fast.
For DMX-controlled operation set DIP Switch 10 to OFF.
Use DIP Switches 1 to 9 to set the desired DMX addresses.
22/47
00026467.DOC, Version 1.0
Publicité
Table des Matières
