Publicité
ENGLISH
three heads are touching the skin with equal pressure.
•
Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
•
DO NOT press hard against the skin in order to avoid damage to the rotary heads.
SHAVING WITH SHAVING GEL
•
Follow the same instructions as dry shaving, noted above in the Shaving section, if
using with gel.
•
Caution: After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance. We recommend you clean
your appliance after each use.
•
Ensure the appliance is switched off and unplugged from the mains before cleaning.
1.
Open the shaver head by pressing the release button (Fig. A).
2.
Empty out any hair clippings.
3.
Pull the shaver head upwards to remove it from the body (Fig. B).
4.
Locate the centre arrow and slide the retainer in the opposite direction to release it.
Once released, lift it out of the shaver head (Fig. C). Make a note of the correct
orientation of the retainer to make refitting easier.
5.
Carefully brush away any hairs from the cutters.
6.
For a more thorough cleaning, lift out the three cutters (Fig. D).
7.
Wash the shaving head unter running water (Fig. E). Allow to dry thoroughly.
8.
Carefully refit the three cutters.
9.
Refit the retainer. Locate the centre arrow and slide the retainer in the same direction
as the arrow until it clicks into place (Fig. F).
10. Once the shaver head is assembled, align the spring hinge with the slot at the back of
the hair pocket and press into place (Fig. G). Finally, close the head assembly.
TRIMMER
Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
•
The rechargeable battery must be removed from the appliance before it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1.
Run the shaver until the motor stops.
2.
Unplug the shaver.
6
Publicité
