Bulldog DC Serie Manuel D'instructions page 11

It may be necessary to rotate the motor or clutch. This will depend on the mounting position or
variables that restrict access to the motor connections or the clutch handle.
1.5 Motor Repositioning
To change the motor mounting orientation
use an 11 mm wrench and remove the 2
screws. Hold the motor and pull back about
a 1/4" and rotate the motor by 90 degree
increments to the required position. Reinstall
the two screws and torque to 10 ft.-lbs. See
Figure 5.
1.5.1 Clutch Repositioning
Change the position of the Free-Spool T-handle
according to the following steps. Loosen and
release the bolts on the brake rear cover. Rotate
the gearbox by proper angle increments. See
Figure 6. Re-assembly the gearbox and rear
brake cover. Torque screws to 5 ft.-lbs.
Clutch
Remove these
Handle
screws to
rotate clutch
DC9000 & DC12000L Models
Rotate by 40˚ Increments
CEQUENT
Installation Instructions
Figure 6 - T-Handle Cluth Postion & Rotation
PERFORMANCE PRODUCTS, INC. •
™
Figure 5 - Motor Position Rotated By 90°
Remove these
screws to
rotate motor
Clutch
Handle
Remove these
screws to
rotate clutch
DC12000, DC15000, DC18000 Models
Rotate by 36˚ Increments
F3838-00 REV A (3576) 10/14
11