Meec tools 011625 Instructions D'utilisation page 21

Table of contents
1 Introduction
1.1 Product description .............................................................21
1.2 Intended use ..........................................................................21
1.3 Symbols ...................................................................................21
1.4 Product overview ................................................................21
2 Safety
2.1 Safety definitions .................................................................21
2.2 General power tool safety warnings .......................22
2.3 Work area safety ................................................................22
2.4 Electrical safety ..................................................................22
2.5 Personal safety ...................................................................22
2.6 Power tool use and care ................................................22
2.7 Service ....................................................................................23
2.8 Specific safety instructions for hammer drill ......23
2.9 Personal protective equipment ..................................23
3 Operation
3.1 To do before you operate the product .....................23
3.2 To adjust the support handle ......................................23
3.3 To use the chuck ................................................................ 24
3.4 To use the different function modes ........................ 24
3.5 To operate the product ................................................... 24
4 Maintenance
4.1 To clean the product ......................................................... 24
4.2 To do maintenance on the product. ......................... 24
4.3 To do a check of the grease level ..............................25
4.4 To fill grease .........................................................................25
5 Storage
5.1 To put the product in storage .......................................25
6 Disposal
6.1 To discard the product .....................................................25
7 Technical data
2022_001
1 Introduction
1.1 Product description
21
The product is an electric hammer drill with 3 function
modes: hammer mode, hammer drill mode, and chisel
mode. A safety switch engages if the tool gets stuck.
1.2 Intended use
The product is intended to be used for drilling holes in, and
21
to remove material from, concrete and metal.
1.3 Symbols
23
24
1.4 Product overview
(Figure 1)
1. Chuck
2. Mode selection knob
3. Grease plug
4. Power trigger
25
5. Status light
6. Support handle
25
2 Safety
2.1 Safety definitions
25
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
Read the operating instructions
carefully and make sure that you
understand the instructions before you
use the product. Save the instructions
for future reference.
Safety class II.
This product complies with applicable
EU directives and regulations.
Recycle as electrical waste.
21