Montarbo M Serie Notice D'emploi page 6

M SERIES
CONTROL PANEL
3
6
4
1 AUDIO INPUTS - UNBALANCED RCA
The relevant electrical connections are
Tip = + "warm" positive
Sleeve = screen or mass
2 AUDIO INPUTS - BALANCED
TRS
Tip = + "warm" positive
Ring = - "cold" negative
Sleeve = screen or mass
XLR
The relevant electrical connections are:
1 = screen or mass
2 = + "warm" positive
3 = - "cold" negative
10
5 3 1
3 BACKLIT LOGO
Button that activates/deactivates the front speaker logo light.
4 HPF
High-pass filter with selectable cut-off frequency (80 Hz / 100 Hz) that can be disabled
(BYPASS position)
5 MAIN LEVEL
Potentiometer to adjust listening audio level
6 HF LEVEL
4-level HF filter gain selector. This filter can attenuate or boost high frequencies,
according to preset values (-2, -1, 0, 1 dB)
POWER SUPPLY
4
1 ON/OFF
Switch for switching the monitor on/off.
2 MAINS INPUT
IEC input socket with integrated mains
2
filter. Each package includes the necessary
power supply cable, specific for your
area. With the loudspeaker off, plug the
power supply cable into this socket. Never
disconnect the earth plug.
3 FUSE HOUSING
: If necessary or upon fuse
WARNING
replacement, make sure that the fuse
holder is placed in the direction indicated
by the arrows on the cover and according
to the electrical voltage in your area. It is
recommended to check this detail before
connecting the unit to the electrical socket.
: Replace the fuse
WARNING
only with one of the same type and with the
same values. If the fuse continues to fail,
contact an authorised service centre.
User manual
1
2
3
11