Alarm Overview - MS Schippers MS Fan Controller Touch Mode D'emploi

4 Alarm overview

This chapter discusses the alarms that the MS Fancontrol Touch can display.
No alarms are active
If no alarms are active, the alarm bell icon is grey.
One or more alarms are active
If one or more alarms are active, the alarm bell icon flashes with a red background, switching between the
alarm bell icon and the alarms that are active.
Also, the alarm relay will be activated.
Resolve or stop an alarm
To deactivate an alarm, simply press the alarm icon that is visible on the home screen.
The alarm relay will be activated,
When the alarm is resolved, the alarm icon will automatically appear gray. If the alarm is not resolved, the
alarm bell icon turns orange, indicating that the alarm has been silenced. If the MS Fancontrol Touch detects
that the alarm is still active within 5 minutes, or if a new alarm situation occurs, the display switches back to
the active alarm bell icon. The alarm relay will activated.
Remark: The various alarm icons can only be displayed if the corresponding control is active and an alarm
occurs in relation to that control.
No alarms: There are no alarms at the moment.
Alarm alert: One or more alarms are active, but are suppressed for 5 minutes.
Alarm: One or more alarms are active and the alarm relay has been activated.
Minimum temperature alarm: The measured room temperature is equal to or
below the set minimum alarm limit.
Maximum temperature alarm: The measured room temperature has risen to
equal to or above the set maximum alarm limit.
Sensor defect alarm: The measured temperature is out of range (lower than -
60°C or higher than 130°C).
IO alert: The communication between the front pbc and the bottom pbc has
been interrupted
MS_FANCONTROL_TOUCH_GEBRUIKERSHANDLEIDING
EN - MS Fancontroller Touch
Page 12
14