Sharp SD-SG11 Mode D'emploi page 43

Using the same timer setting
Once memorized, the timer setting can be used as follows.
1
Press the TIMER/DELETE button.
2
Within 10 seconds, press the REC LEVEL/CURSOR
to select "STANDBY".
If "STANDBY" is not displayed, the clock setting has been cleared.
In this case, reset the clock and the timer.
3
Within 10 seconds, press the ENTER button.
The timer setting is displayed in order.
The unit will enter the stand-by mode and then the playback or recording stand-by
mode automatically.
Notes:


The timer setting will be cleared when the unit is unplugged or the power failure
occurs.


The timer playback is possible with a CD or MD even if the repeat, random, or pro-
grammed playback is set.


When performing timer playback or recording using another unit connected to the
AUX IN or DIGITAL IN jacks, select "AUX" or "OPT" in step 11. At this time, only
this stereo system will enter the stand-by mode automatically. (Another unit will not
be turned off.)
To check the timer setting:
1 While in the timer playback or timer recording stand-by mode, press the TIMER/
DELETE button.
2 Within 10 seconds, press the REC LEVEL/CURSOR
"TIMER CALL".
or button
3 Press the ENTER button.


After the timer setting is displayed in order, the display will return to normal.
To change the timer setting:
Perform "Timer playback/Timer recording" from the beginning. (See pages 38 -39).
To cancel the timer playback/timer recording:


If the power is turned on while in the playback or recording stand-by mode, the
timer setting will be canceled.


Proceed as follows to cancel without turning the power on.
1 Press the TIMER/DELETE button.
2 Within 10 seconds, press the REC LEVEL/CURSOR
"CANCEL".
3 Press the ENTER button.
or button to select
or button to select
01/7/12 38-48.fm
SD-SG11
E
F
E-40