Starting System - Eneo MSR-24N040004A Guide D'installation Rapide

3. Install HDD in the bottom case.
4. Connect a data cable and power cable with HDD.
5. Close the cover and tighten screws.

Starting System

Power supply begins with system operation as follows:
1. Switching on initialize with below icons in order.
i Notice: Installing new HDD might take more initialize time.
2. With buzzer sounds, the start screen is presented.
3. In Log in screen, enter the ID, Password and press OK.
i
Notice: Default ID & Password is admin/admin
CAUTION:
Please change password after login due to security.
For security reasons, please note in the event the password is
lost the device must be returned to our Service Centre so the
password can be reset.
EN
9