Ariston Chaffoteaux 3318905 Installation Et Mode D'emploi page 40

GB
start-up
LECTORS INSTALLED)
Press OK button to return to the previous
visualisation.
- GUIDED PROCEDURES
(The guided procedures are a valuable aid
when installing a solar heating system. Turn-
ing the knob allows selection of a list of pro-
cedures that explain - step-by-step - how to
perform installation correctly)
Turn the knob and select:
Press the OK button.
Turn the knob and select from the following:
- First fi lling of the system
- Solar circuit air purge
- Solar circuit pressure setting
- Solar circuit fl ow rate setting
Press the back "
mode menu appears on the display.
Turn the knob and select:
- TEST MODE
(The test mode allows checking for correct
operation of the components connected to
the system. Turn the knob to select the list of
tests that can be performed)
Press the OK button.
Turn the knob and select from the following:
- Solar pump test
(activates the circulation pump)
- Solar 3-way valve test
(switches the 3-way valve)
- Solar AUX1 test
(shuts the auxiliary contact)
- Electrosolar Out test
(enables the heating element)
- Stepper mix test
(opens and closes the mixing valve)
Press the OK button to return to the previous
screen.
Press the back "
If the PCB needs to be confi gured (for ex-
ample, when it is replaced), the relative
parameters can be set through the Main-
tenance menu.
40
" button until the Test
" button to exit test mode.
Simultaneously press the back "
"OK" buttons until "Enter code" appears on
the display.
Turn the knob to enter the technical code
(234) then press OK; the display will visual-
ise TECHNICAL AREA.
Turn the knob and select:
- SERVICE
Press the OK button.
Turn the knob and select:
- Solar control
Press the OK button.
Turn the knob and select:
- Confi guration parameters
Press the OK button.
Turn the knob and select:
- Solar P.C.B. setup
Press the OK button.
Turn the knob and select:
- 3 2 1 Hydraulic scheme
Turn the knob to set the reference hydrau-
lic circuit diagram according to the instal-
lation performed:
0 Not defi ned
1 Basic single-coil
2 Basic double-coil
3 Electrosolar
4 Heating support
Press the OK button.
The display will visualise the selected set-
ting.
Press OK button to return to the previous
visualisation.
Turn the knob and select:
- 3 3 1 Digital solar pump
Press the OK button.
Turn the knob and set the value as indi-
cated in the manual or instruction sheet
accompanying the electronic PCB spare
part.
Press the OK button.
The display will visualise the selected set-
ting.
Press OK button to return to the previous
" and