GB
installation
PRECAUTIONS
PRIOR TO INSTALLATION
The module is designed for being installed
on the wall or directly on the storage tank
(if appropriately confi gured). It therefore
cannot be installed on a fl oor-standing
base or on the fl oor. When creating a tech-
nical compartment for housing the module,
leave suffi cient space around the module to
ensure easy accessibility.
Verify that all the module's components
have remained intact following transport
and handling, and have not been damaged
by knocks.
In case of evident damages to the product,
do not proceed with installation.
CAUTION
When drilling the wall, take care not to
damage any electrical wiring or existing
piping.
30
WALL INSTALLATION
After identifying a suitable wall, drill a hole
in the latter and insert one of the two wall
plugs provided, while taking care not to
damage existing electrical wiring or piping.
For the positioning, refer to the picture be-
low.
Position the module on the wall, against the
previously drilled hole. Secure the module
to the wall through the central hole of the
mounting bracket using the screws provid-
ed, as described in the picture sequence.
If the wall plugs provided are not suitable
for the type of chosen wall, replace them
using expansion plugs suitable for the type
of wall and weight of the module.
Tighten the screws and verify that the mod-
ule lies level.
Verify that the entire module rests fully
against the wall and lies level, both hori-
zontally and vertically.
If not, perform the necessary adjustments
by intervening on the bracket's fi xing
screws.
67
275
138