Condensate Drains - TECHTOP NEMA Serie Instructions

Moteurs à basse tension
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
FRANÇAIS
11.1 CONTINUED
Frame
NEMA
364T
365T
404T
405T
444T
445T
447T
449T
500
For IEC frame, select the lower value of the equivalent NEMA frames.
If the application calls for significant thrust loads, please contact Techtop to
determine if you have the correct motor for your application.
Note
s:
1.
Overhung loads are considered to include belt tension and sheave weight.
2.
Belt loads considered to act in a vertically downward direction.
3.
To determine load at shaft end subtract 15%.
4.
Overhung load radial limits are based on a bearing L-10 life of 26,280 hours.
5.
Overhung load limits don't include effects of any unbalanced magnetic pull.

12. CONDENSATE DRAINS

Many Techtop motors come standard with one way sintered brass breather drains.
These drains allow the motor to expel liquids from the casing without allowing liquid
to enter the motor. Drains may require periodic maintenance to keep them clean
of debris and flowing freely. Occasionally, remove the brass drains and wash them
thoroughly. Eliminate any built up debris which may be impeding their operation.
For motors which are equipped with rubber plugs in their condensate drain holes,
be sure to remove the plug (i.e. especially if the motor is installed in a location where
condensate build up is likely).
In all instances, ensure that the drain is in the lowest portion of the motor. Some
motors may require rotation of the end plates (i.e. if the mounting location is not
a typical horizontal mounting).
TechtopCanada.com
3600 RPM
IEC
225S
225M
250M
280S
280M
--
315S/M/L
1800 RPM
820
1080
820
1080
--
1270
--
1290
--
1560
--
1520
--
1450
--
1490
--
1490
Units are in pounds (lbs)
1200 RPM
1240
1240
1450
1480
1760
1760
1660
1660
1660
Techtop Motors | 16

Publicité

Table des Matières
loading

Table des Matières