Introduction; Safety Notice - TECHTOP NEMA Serie Instructions

Moteurs à basse tension
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1. INTRODUCTION

Before you install, operate or perform maintenance, become familiar
with the following:
• NEMA Publication MG-2: Safety Standard for Construction and Guide for
Selection, Installation and Use of Electric Motors.
• IEC 60034-1 Electrical and IEC 60072-1 Mechanical specifications
• ANSI C51.5, the National Electrical Code (NEC) and local codes and practices.
• OSHA standard 1910.147 titled: The Control of Hazardous energy
(lockout/tag-out).

2. SAFETY NOTICE

Only qualified personnel, trained in the safe installation and operation of this
equipment, should install this motor. When improperly installed or used, rotating
equipment can cause serious or fatal injury. Equipment must be installed in
accordance with the National Electrical Code (NEC), local codes and NEMA MG2
Safety Standards for Construction and Guide for Selection, Installation and Use
of Electric Motors and Generators and OSHA regulation standard 1910.147 titled:
The control of hazardous energy (lockout/tag-out).
Use correct material handling equipment to avoid injury. Use caution when
removing the motor from its packaging. Sharp corners may exist on motor shaft,
motor key, sheet metal and other surfaces.
1.
Connect Power and Ground to the motor according to NEC or IEC and local
codes.
2.
Provide a permanent guard to prevent accidental contact of body parts or
clothing with rotating or moving parts of motor. Beware of burns if motor is hot.
3.
Shaft key must be secured before starting motor.
4.
Mounting bolts should be high tensile steel. Be sure to use a suitable locking
device on each bolt (spring washer or thread lock compound).
5.
Do not apply power to the motor until the motor is securely mounted by its
mounting holes.
6.
This motor must only be connected to the proper line voltage, line frequency
and load size.
3 | Techtop Motors
WARNING:
All operations must be carried out by
appropiately trained personnel. Electric motors have
energized circuits and exposed rotating parts which
may cause injuries to people.
ENGLISH
FRANÇAIS
TechtopCanada.com

Publicité

Table des Matières
loading

Table des Matières