Reggiani MORPHY Instructions De Montage page 8

4) Proceed in the reverse order reassembling first the last sector
removed through wedges and optional stop screws
having definitively oriented the fixture.
RELAMPING.
- Disconnect from mains.
- Enter the components compartment by first removing the very
"external" sector and relamp: proceed as above (one or more
sectors).
- Make sure that contacts between lamp and lampholder are
correct and secure.
- Close the fixture following the reverse order of the operations.
Tighten the sector optional stop screws
oriented the fixture.
- Remind that maximum vertical inclination allowed for metal
halide double-ended lamps is 45°. Further inclination would
bring about colour deviations over time.
ACCESSORIES
EDGE/CORNER MOUNTING ACCESSORY (dwg.
- Fix flange
wedges into relevant holes. Put toothed washer
support plate
through pieces in the mini-kit supplied with accessory (gasket
O
, washer
R1
- Follow mounting instructions of the fixture.
BARNDOORS
- See dwg. .
ANTI-GLARE LOUVRE
- See dwg. .
SUSPENSION BRACKET
Provide for the electrical connection by inserting the mains cable
in the tube and connecting it to the fixture through special
connecting device supplied.
- To mount on a wall (Dwg.
Separate cover
screws. Fix support
to be fournished by the installer. Remember to put on support
toothed washer
as shown in dwg.
screw into any hole on the support and tightening it on the
other side with relevant bolt. Hence, reposition cover
ENGLISH
to the edge/corner by means of expansion
and accessory
O
, screw ) as shown in dwg.
V1
)
from support
on the wall using expansion wedges
O
and flat washer
R2
. Bracket direction is adjustable through
8
O
only after having
A1
O
R2
. Fix support plate
.
by loosening lateral fixing
O
supplied with accessory,
R3
O
after
A1
bis)
between
on
MORPHY