Removal From Window - Kenmore 35910 Manuel De L'usager

18
FRONT INSTALLATION
Install the front grille(packed separately) onto the
cabinet as follows:
• Hook upper tabs of front grille into slots on the
cabinet top. (FIG. 19)
• Push front grille's tips towards the cabinet in order
to snap side tabs into the cabinet. (FIG. 19)
• Open the inlet grille. (FIG. 20)
• Install the screw (ITEM E) through the front grille.
(FIG. 20)
• Close inlet grille. (FIG. 21)
Front Installation
ITEM E
Front Installation
Front Installation
IF AIR CONDITIONER IS BLOCKED BY
19
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood strip to the inner window sill across the full
width of the sill. The wood strip should be thick
enough to raise the height of the window sill so that
the unit can be installed without interference from the
the storm window frame. See FIG. 22.
INSTALLATION
• Install a second wood strip (approximately 6" long by

REMOVAL FROM WINDOW

FIG. 19
• Turn off and unplug the air conditioner.
• Remove the front grille. See HOW TO REMOVE THE
• Unscrew the side screws that you installed in Step 15.
• Slide the air conditioner out of the cabinet.
Inlet grille
• Remove the L bracket from window frame and the sash
• Unscrew the side curtains from the window frame. Fold
FIG. 20
• Remove screws attaching cabinet to inner sill. Be careful
• Remove cabinet from window opening.
• Place air conditioner into cabinet. Reinstall side screws
• Place unit and all assembly hardware in air conditioner
FIG. 21
• Air conditioners covered in this manual pose an
• When handling the air conditioner, be careful to
• Make sure air conditioner does not fall during
- 8 -
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside.
1
1 / " wide and same thickness as first strip) in the
2
center of the outer sill flush against the back of the
inner sill. Screw the L brackets into this strip.
This will raise the L bracket as shown in FIG. 22.
WOOD STRIP MOUNTED
ON TOP OF INNER SILL
INNER
L BRACKET
SILL
WOOD STRIP
FOR L BRACKET
INSIDE
FRONT GRILLE. Refer to page 13.
BE CAREFUL NOT TO DROP IT. Hold onto it firmly the
whole way sliding it out. Once removed, set it safety out
of the way.
seal from between the windows.
them back to the sides of the cabinet.
not to let cabinet fall once screws are removed.
and Front Grille.
shipping carton, and store in clean, dry place.
CAUTION
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
avoid cuts from sharp metal fins on front and
rear coils.
removal.
1 1/2" min.
(38mm)
3/4"
CLEARANCE
STORM
WINDOW
FRAME
OUTER
SILL
OUTSIDE
FIG. 22