Kenmore 35910 Manuel De L'usager page 7

8
Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
Lower guide
INDOOR
9
Place the sill supports with the cabinet on the
window sill's selected position.
10
The cabinet should be installed with a very
slight tilt (about 1/4") downward toward the outside
(FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
11
Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the Lower Guide into the
window inner sill (FIG. 12).
ITEM B
12
Pull each side curtain fully to each side of
window opening.
Attach each side curtain to the window sash using
screws (ITEM G). (FIG. 13)
INSTALLATION
ITEM E
Cabinet
OUTDOOR
FIG. 10
ITEM B
FIG. 11
Sash
Track
Lower Guide
ITEM F
FIG. 12
ITEM G
FIG. 13
- 7 -
13
Attach the L BRACKET (ITEM J) with screw
(ITEM G). (FIG. 14)
ITEM J
14
DRAINAGE
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
(1/4") downward to the outside for proper drainage of
excess condensed water through the drain pipe.
(FIG. 15)
BASE PAN REAR
DRAIN PIPE
BASE PAN BOTTOM
15
Slide the chassis into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side
screws you removed in step 1.
Screw
16
Cut the foam strip (ITEM H) to the proper length
and insert between the upper window sash and the
lower window sash. (FIG. 17)
ITEM H
17
The vent control handle must be straightened
before the decorative front is attached.
Pull out part to align with part
Part A
ITEM G
FIG. 14
FIG. 15
Power
Cord
FIG. 16
Screw
FIG. 17
.
Part B
FIG. 18