Clarisonic MIA SMART Mode D'emploi page 7

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC (Federal Communications Commission) Rules. This equipment complies with
Canadian standard ICES-003.
U.S. FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 and Part 18
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Clarisonic could void the user's authority to operate
the equipment.
Canada IC Statement: This device complies with industry standards of Canada license exempt RSS
standards. Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired operation
of the device.
Treatment of electrical and electronic equipment applicable at the end of life in the European Union
and other European countries with selective collection systems: This product should not be treated as
household waste but should be handled at a designated collection point for the recycling of electrical and
electronic equipment. Please contact your local authority for further details of your nearest designated
collection point.
RED statement for EU: This device uses Bluetooth Low Energy technology (BLE v 4.2 only and not Bluetooth
Classic). Frequency Band: 2.4 GHz (2.402-2.480 GHz, Max Power: 0 dBm).
CHARGING
Allow approximately 18 hours for a full charge. A fully charged device averages 60 minutes of use
depending on the type of brush head used.
CARING FOR YOUR DEVICE
To keep your Clarisonic device and accessories in optimum condition, care for it as follows:
Do not use abrasive cleansers, chemicals or exfoliators to clean any part of the Clarisonic device
or accessories.
Do not put any part of the Clarisonic device or accessories in the dishwasher.
The device is sealed and fully waterproof. Never attempt to open the device for any reason. If you are not
using the device for long periods of time (weeks/months), unplug the charger and store the device in a cool
dry place away from direct sunlight. Charge the device every 6 months to maintain its charging capabilities.
DEVICE DISPOSAL AT END OF PRODUCT LIFE: Your Clarisonic device is sealed and contains rechargeable
NiMH batteries. These batteries are non-replaceable and the sealed device is non-repairable. When your
device reaches end of life: it no longer holds a charge, does not function and is out of warranty; this device
must be recycled or disposed of per your local regulations. Do not dispose of it in fire.
CUSTOMER SERVICE AND WARRANTY INFORMATION: www.clarisonic.com/service
4