Beninca PONY 115 Mode D'emploi page 19

Use several manual opening and closing manoeuvres to check that the
rack is correctly engaged, along its entire length. If necessary, the holes
present on the rack allow height adjustment.
In the inspection phase, use several opening and closing manoeuvres to
check whether the end run intervenes in the correct opening and closing r the
points, before the respective mechanical profiles. the
If necessary, move the brackets FRD.1 to advance or delay the stop points
Fig. 20 Fig. 21
2/3 cm
Fig. 17
1 m
m
Fig. 19
Fig. 22
ma ma ma
ng
Fig. 24
Fig. 18
Fig. 23
2/3 cm
Fig. 25
EN
19