Häfele 442.48.900 Mode D'emploi page 8

5
.) Track installation
Installation of left running track (e.g. Spax screws) – milled-out area(*) at top
•
Slide in lock strip (right + left guides attached to lock strip) left-aligned
•
Installation of right running track (e.g. Spax screws), same as left running track
•
Install panels if necessary
•
(*) = Milled-out area, notch in rear of running track (length) (dimension "A") depends on the cabinet
design, the board thicknesses that have been used, and the facing of the radius inlet (dimension "B")
of the roller shutter = facing situation (PP - panel; shutter profiles; wooden panel or the like)
The situation shown in the diagram is a schematic diagram and must be individually adapted to the
cabinet design, the installation location of the counterbalancing mechanism (dimension "B") and the
dimensional situation.
Running track as shown in figure (item 5), notched for shutter profiles as radius inlet facing.
„A"
Installation is finished and system is ready to use.
8/24
Running track, left
Secured using Spax screw, for example
60
„A"
„B"