Hilti SL 2-A12 Mode D'emploi Original page 7

be attached to your power tool does not necessarily mean that it can be
used in safety.
▶ Replace the complete cordless lamp when the light source has reached
the end of its life. The light source in this cordless lamp is not replaceable.
▶ Do not look into the beam and do not direct the beam toward other
persons.
▶ Do not expose the device to rain or moisture. Water entering an electric
device will increase the risk of electric shock.
2.3 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and
use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not take apart, squash or incinerate batteries and do not subject them
to temperatures over 80 °C.
▶ Do not attempt to charge or continue to use damaged batteries.
▶ If the battery is too hot to touch, it may be defective. In this case, place
the power tool in a non-flammable location, well away from flammable
materials, where it can be kept under observation and left to cool down.
Contact Hilti Service after the battery has cooled down.
3 Description
3.1 Product overview
Multi-position hinge
@
LED bezel
;
LED
=
Retractable hook
%
Automatic switch
&
3.2 Intended use
The product described is a cordless lamp. It is intended for use as illumination
on jobsites. Use the product in a dry environment only.
SL 2-A12
Use only Hilti Li-ion batteries from the B 12 series with this product.
▶ Use only the Hilti battery chargers of the C 4/36 series with the CA-
B12 charging adapter, or battery chargers of the C 4/12-50 series for
charging these batteries.
Printed: 21.04.2017 | Doc-Nr: PUB / 5346559 / 000 / 00
1
(
)
+
§
3-mode switch
Grip
Battery
Battery release button
English 3