SAFETY CUT-OUT
This cordless water kettle is protected with an automatic safety
•
device, if accidentally switched on without water. Please bear in
mind that only the thermostat is switched off in case of overheat,
whereas the switch stays in the ON-position.
If this happens, switch off the appliance by putting the switch in the
•
OFF position and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element. This will
reset the safety device.
The kettle may then be used as normal.
•
CLEANING AND MAINTENANCE
Before attempting any cleaning operation, make sure the
•
appliance is unplugged from the supply socket and fully cooled
down.
To clean the exterior surfaces, simply wipe over with a soft, damp
•
cloth and dry thoroughly.
Never use abrasive products, powders or scouring pads.
•
Under no circumstances shall the jug kettle or its power base be
•
immersed in water.
To remove mineral deposits from the water kettle, use products
•
(decalcifying solutions) made especially available for this purpose.
Make sure to use a type recommended for kettles or coffee makers.
Follow the guidelines as recommended by the manufacturer of the
de-calcifying solution. Rinse well.
FILTER
•
Your appliance is provided with a mesh filter. This filter is factory pre-
installed before the spout.
•
The filter is placed in front of the spout. Filter should be rinsed clean
regularly. For this, press the filter out, rinse under water, and put it
back into position once clean.
www.KALORIK.com
8
JK 42458 - 200421