Installing The Anti-Tip Device - AGA MARVEL ML24BCGO Instructions D'installation, D'utilisation Et D'entretien

WARNING
!
•
•
•
Anti-Tip Device
WARNING
!
If your beverage center is not located under a counter
top (free standing), you must use an anti-tip device
installed as per these instructions. If the beverage
center is removed from its location for any reason,
make sure that the device is properly engaged with
the anti-tip bracket when you push the beverage
center back into the original location. If the device is
not properly engaged, there is a risk of the beverage
center tipping over, with the potential for property dam-
age or personal injury.
NOTE
If installing on a concrete floor, concrete fasteners are
required, (not included with the anti-tip kit).
CAUTION
!
Any finished flooring should be protected with appropriate
material to avoid damage when moving the unit.
Floor Mount Installation
The anti-tip bracket is to be located on the floor in the left or
right rear corner of the beverage center as shown in
Figure 7.
All manuals and user guides at all-guides.com
INSTALLING THE ANTI TIP DEVICE
FOR FREESTANDING INSTALLATIONS
ALL APPLIANCES CAN TIP
RESULTING IN INJURY.
INSTALL THE ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
FOLLOW THE INSTRUC-
TIONS BELOW
Anti-Tip
Bracket
Leveling Leg
Bottom View of
21 ⁄ "
1
2
(54.6 cm)
Step by step instructions for locating the
position of the bracket:
1) Decide where you want to place the beverage center.
Slide it into place, being careful not to damage the floor,
leaving 1" (2.5 cm) of clearance from the rear wall to allow
room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the beverage center is in the desired location,
then mark on the floor the rear and side corner of the cabi-
net where the anti-tip bracket will be installed. If the instal-
lation does not allow marking the rear corner of the cabinet,
then make temporary lines on the floor marking the front
corner of the cabinet, excluding the door. Slide the bever-
age center out of the way. From the temporary line extend
the sidewall line back 21
4) Align the anti-tip bracket to the marks on the floor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21 ⁄
1
2
line).
5) Fasten the anti-tip bracket to the floor using the supplied
screw. (See Figure 8).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.
6
Beverage
center
Front of cabinet
Figure 7
⁄ " (6 mm) to
1
4
⁄ " (54.6 cm) as shown in Figure 8.
1
2
" (54.6 cm) line (Rear of cabinet