Chauvet Professional WELL 2.0 Mode D'emploi page 3

EN
Replacing the
Fuse
Battery Charge
Notes
DMX Connection
DMX Linking
Master/Slave
Connection
The standalone battery charger has no external fuse. However, the flight
case/charger comes with a replaceable fuse.
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap
from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back in place and reconnect power.
·
Make sure to turn the battery storage switch on before connecting the
product to the charger.
·
Always use the supplied charger to recharge the built-in battery.
·
Recharge the battery within three days of last use.
·
Recharge the battery to full capacity before storing this product.
·
For best results, charge the battery in a temperature between 32º F (0º
C) and 95º F (35º C).
·
When charging the battery, keep the product at no less than 1 m from
any open flame or hot plate.
·
When charging the battery inside the flight case/charger, keep the
flight case's cover open.
·
Always charge the battery with the product in an upright position.
·
Do not keep charging the battery for more than 24 hours.
·
Perform a full discharge/recharge cycle every three months.
·
During charging, the green power indicator LED will illuminate solid,
regardless of the level of charge of the battery.
·
Once fully charged, while still connected to the battery charger, the
green power indicator LED will turn off.
The WELL™ 2.0 uses a regular or wireless DMX data connection for its
DMX personalities: TOUR, ARC.1, AR1.d, AR1.S, BLOC, and HSV.
See the User Manual to connect and configure for DMX operation.
The WELL™ 2.0 will work with a DMX controller using a regular DMX
serial connection or via W-DMX™. A DMX Primer is available from
www.chauvetpro.com.
The WELL™ 2.0 uses the DMX data connection for its Master/Slave
mode. See the User Manual to connect and configure for Master/Slave
operation.
3
WELL™ 2.0 QRG