in-lite FISH EYE LOW HIGH WW Manuel D'utilisation page 4

EN
Contents
1x FISH EYE LOW/HIGH (WW) 12 V / 5 W
1x ground stake
1x stainless steel ring
3x fixing screws
1x Easy-Lock
1x Torx key
Material
Stainless steel, impact-resistant polycarbonate
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Although a 12 V system is safe, we advise you to have a qualified
electrician check the installation.
Use
This fixture can be used in two ways:
With top reflector
Suitable for above-ground lighting in the yard or to mark a pathway,
drive or patio.
Without top reflector
Suitable as a spot light to illuminate special places in the yard. Use the
360° rotating light unit light unit for this. To direct the 'Fish Eye', you
must first slightly loosen the three screws of the top plate. Turn the eye
to the desired position and then fix it in place by tightening the screws.
Attention! Do not over-tighten the screws; only tighten them enough to
fix the eye in place.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life (about 25,000 hours) and a high light output and their
power consumption and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
The fixture is delivered ready assembled and with a top reflector. To
use without the top reflector loosen the three Torx screws and replace
the top reflector with the stainless steel ring supplied.
Step 1
The fixture can be mounted on a hard surface using the screws sup-
plied or in soft surface using the ground stake supplied. The ground
stake is easily fixed by screwing it in the underside of the foot of the
fixture.
When using on a hard surface first remove the black ground plate from
the foot of the fixture by loosening the Torx screws. Next, fix the plate
to the surface using the screws supplied. Then place the fixture back
onto the ground plate and tighten the Torx screws.
Step 2
Join the Easy-Lock connector to the main cable. (Fig. 1)
a. There are two cable grips. The grip with the wider recess fits the
10/2 main cable, the grip with the narrower recess fits the 14/2
main cable. Clamp the correct cable grip over the main cable.
b. Put the cable grip (with the cable underneath) in the Easy-Lock
connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 3
Connect the power cable to the fixture by connecting the mini-
connector. (Fig. 2)
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 2 and 3. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.