Risk of scalding!
After connection to the coupling (27b), hot water
immediately runs out of the drainage hose (28).
Attach the angled end of the drainage hose (28)
■
to the coupling (27b) and release the hot water
from the tank into the basin prepared for this
purpose.
Remove the drainage hose (28) and close the
■
opening with the red safety lock cap (27a).
Slide the sliding door (27) upward.
■
Remove the collection tray with drip grate (26),
■
then empty and rinse it.
Filling the water tanks
Open the water supply again. Insert the appli-
■
ance's electrical plug in the electrical socket and
switch the On/Off switch (14) to I.
Press and hold the selection button
■
water) for approx. 3 seconds to switch on the
cold water function.
It will take about 2 hours until all three tanks are
refilled.
Drain the tanks once more and then refill as de-
■
scribed in Chapter "Draining the water tanks" and
"Filling the water tanks".
The appliance is ready to operate when both LED in-
dicators "Hot water" (17) and "Cold water" (18) light
up completely.
LED Hot water
34
All manuals and user guides at all-guides.com
en
Operation
Important
The appliance must be connected and switched on.
By pressing the corresponding button, you can
easily select between
■
(Cold
■
■
LED Cold water
Water flows into the glass.
Hot water
Ambient water
Cold water
Press the desired water temperature button, e. g.
the selection button
(Cold water).
Now, set a glass under the water outlet.
Press the dispensing
button.