Mounting The Scroll Station To Plywood - Dremel 1800 Mode D'emploi

Assembly
Mounting the Scroll Station
to Plywood
24"
An alternative method of securing your Scroll Station is to
fasten the Scroll Station base to a mounting board 18" x 24".
Any good grade of plywood with a 3/4" minimum thickness is
11-7/8"
recommended. Follow the instructions for MOUNTING THE
SCROLL STATION TO A BENCH, substituting the 18" x 24"
board for the workbench and using 1/4"-20 flat head screws
7-7/8"
15"
for the hex head bolts (Figure 7). Screws must be mounted
from underneath the plywood with washers and nuts on top.
NOTE: For proper stability, holes must be countersunk so
19-13/16"
screw heads are flush with the bottom surface of the sup-
porting board.
Figure 8. Plywood Mounting Template
Securely clamp board to workbench using two or more "C"
clamps.
13