Mounting The Scroll Station To A Bench - Dremel 1800 Mode D'emploi

Mounting the Scroll Station
to a Bench
The Scroll Station should be fastened securely to a firm sup-
porting surface such as a stand or workbench, using the three
mounting holes.
NOTE: When mounting this saw to a workbench, a solid
bench is preferable to a plywood bench where noise and
vibration will be more noticeable.
We recommend to reduce noise and vibration, that a soft
foam pad be placed between your Scroll Station and work-
bench (not included).
Quantity Description
1 Soft foam pad, such as carpet padding,
24"x12"x1/2"
When mounting the Scroll Station to a workbench, holes
should be drilled through the foam pad or carpet and mount-
ing surface of the workbench using the dimensions illustrated
in Figure 6.
Each of the three mounting holes should be bolted securely
using no less than 1/4" hex bolts, flat washers, lockwashers,
and nuts (not included). We recommend:
Quantity Description
4 Hex Head Bolts,
1/4"-20 x 1/4"-20 x Length Required
4 Flat Washers, 9/32" I.D.
4 Lockwasher, 9/32" I.D.
8 Hex Nuts, 1/4"-20
(Hardware not included)
Refer to Figures 6 and 7.
1. Locate and mark where the Scroll Station is to be mount-
ed.
2. Drill the three (3) 5/16" holes through the workbench.
3. Place the Scroll Station on the workbench aligning holes
in the base with the holes drilled in the workbench. Insert
all three (3) bolts and secure using washers, lockwash-
ers and nuts.
NOTE: Do NOT overtighten mounting bolts. If using recom-
mended foam pad, leave some cushion in the foam pad for
absorbing noise and vibration.
Assembly
Figure 7. Table Mounting Hardware (not included)
12
11-7/8"
19-13/16""
Figure 6. Bench Mounting Template
7-7/8"