Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 70 ft. (21 m); 100 ft.
(30.5m)withRangeBoost. [varies
with surrounding temperature]
Sensing Angle . . . . . . Up to 270°
Electrical Load. . . . . . Up to 300 Watt Maximum In-
candescent [Up to 150 Watt
maximum each lamp holder]
Up to 60 Watt Maximum PAR
38 dimmable self-ballasted
CFL (SBCFL) [Up to 30 Watt
maximum each lamp holder].
SYMPTOM
Lights will not come on.
Lights come on in daylight.
Lights come on for no ap-
parent reason.
Lights turn off too late in
Dusk-to-Dawn setting
Lights stay on
continuously.
Lights flash on and off.
Lights flash once, then stay
off in Manual Mode.
204067-01
OR
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1. Light switch is turned off.
2. Flood light is loose or burned out.
3. Fuse is blown or circuit breaker is turned off.
4. Daylight turn-off is in effect (recheck after dark).
5. Incorrect circuit wiring, if this is a new installation.
6. Re-aim the sensor to cover desired area.
1. Light control may be installed in a relatively dark location.
2. Light control is in Test. (Set control switch to an ON-TIME position).
1. Light control may be sensing small animals or automobile traffic (re-aim sensor).
2. Range is set too high. (Reduce Range).
3. D
B
Timer is on.
®
ual
rite
1. Sensor is in a relatively dark location. (Relocate sensor, or use 3 hr or 6 hr setting.)
1. A flood lamp is positioned too close to the sensor or pointed at nearby objects that
cause heat to trigger the sensor. (Reposition the lamp away from the sensor or nearby
objects).
2. Light control is pointed toward a heat source like an air vent, dryer vent, or brightly-painted
heat-reflective surface. (Reposition sensor. Reduce Range).
3. Light control is in Manual Mode. (Switch to Auto.)
1. Heat or light from the lamps may be turning the Light control on and off. (Reposition
the lamps away from the sensor).
2. Heat being reflected from other objects may be affecting the sensor. (Reposition sen-
sor).
3. Light control is in the Test mode and warming up. (Flashing is normal under these
conditions. Turn Boost off.)
4. Light may be leaking through the flood lamp reflectors. (Replace the lamps with new high
quality PAR 38 lamps or make sure the metal lamp protectors are installed).
5. Light control is in AlertFlash mode. (Flashing is normal in this mode. Select Security
or BulbSaver mode to turn flash mode off).
6. CFL bulb may not be dimmable type bulb. (Use only dimmable self-ballasted CFL
(SBCFL) bulbs.)
1. Sensor is detecting its own lights. (Reposition lamps to keep area below the sensor
relatively dark.)
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO and MANUAL
Lamp Modes . . . . . . . Security, BulbSaver, Alert-
Time Delay . . . . . . . . 1, 5, 20 minutes
D
B
Timer . . . . 3, 6 hours, Dusk-to-Dawn
®
ual
rite
HeathCo LLC reserves the right to discontinue prod-
ucts and to change specifications at any time without
incurring any obligation to incorporate new features
in products previously sold.
5
MODE
Flash
Publicité
