TFA 60.1512 Mode D'emploi page 8

TFA_No. 60.1512_Anleitung_11_16
Radio-controlled alarm clock
4. For your safety
• This product is exclusively intended for the field of application described
above. It should only be used as described within these instructions.
• Unauthorized repairs, modifications or changes to the product are prohibited.
Caution!
Risk of injury:
• Keep this instrument and the batteries out of the reach of children.
• Batteries must not be thrown into a fire, short-circuited, taken apart or
recharged. Risk of explosion!
• Batteries contain harmful acids. Low batteries should be changed as soon
as possible to prevent damage caused by leaking. Never use a combina-
tion of old and new batteries together, nor batteries of different types.
• Wear chemical-resistant protective gloves and safety glasses when hand-
ling leaking batteries.
Important information on product safety!
• Do not place your device near extreme temperatures, vibrations or shocks.
• Protect it from moisture
5. Elements
A: Buttons:
A 1: SNOOZE/LIGHT button
A 2: SENSOR ON/OFF switch
14
23.11.2016 15:57 Uhr Seite 8
Radio-controlled alarm clock
A 3: ALARM/ON/OFF switch
A 4: ALARM dial
A 5: REC button
A 6: SET button
A 7: RESET button
B: Housing:
B 1: Battery compartment
6. Getting started
• Open the battery compartment and insert two new batteries 1.5 V AAA,
polarity as illustrated.
• Close the battery compartment again.
• The device is ready for use.
6.1 Reception of the DCF frequency signal
• The device will alert you with a beep.
• The clock hands move to 12.00 o'clock.
• The clock will now scan the DCF frequency signal.
• When the time code is received successfully after 4-16 minutes, the
radio-controlled time is displayed steadily on the display.
• The DCF reception always takes place hourly between 1:00, 3:00 and 5:00
o'clock in the morning and 13:00, 15:00 and 17:00 in the afternoon. If the
reception is not successfully received until 17:00 o'clock, the next receive
operation is again at 1:00 o'clock in the morning.
15