Auto Changeover Set Point Offset; (Dead Band) - GE RAK180W1 Manuel Du Propriétaire Et Instructions D'installation

Custom Energy Savings Settings
20 – AUTO CHANGEOVER SET POINT OFFSET

(DEAD BAND)

(00°F - 04°F; 01°F* default setting) Select the difference
between the guest-selected set point and the heat and
the cool set point when the thermostat is in the automatic
temperature control mode.
This value plus the 1st stage differential defined in
steps 02 and 04, defines the temperature at which the
thermostat would automatically change heating/cooling
modes.
This feature allows adjusting the dead band between the
heat and the cool set points in automatic changeover
mode in order to avoid the system from bouncing back
and forth between heating and cooling under normal
operating conditions.
40
49-5000416 Rev. 1