Texas SNOWBUSTER 1100E Manuel page 39

How to:
1. Empty fuel tank for old gasoline and refill fresh.
2. Pour the fuel addtive in the tank.
3. After filling fuel additive into the tank. Idle run, the engine outdoors for 10 minutes.
This will blend the fuel mixture in the engine block and carburetor.
4. Stop the engine, and move the fuel valve to the off position.
Precautionary measures against moist
In order to minimize the parts to impair from moist please do as follows:
1. Change the engine oil.
2. Remove the spark plugs.
3. Pour a tablespoon (5-10 cc) of clean engine oil into the cylinder.
4. Pull the starter rope several times to distribute the oil in the cylinder.
5. Reinstall the spark plugs.
6. Pull the starter rope slowly until resistance is felt. This will close the valves so moisture cannot
enter the engine cylinder. Return the starter rope gently.
General advice

Select a well-ventilated storage location, with low humidity in order to prevent rust and
corrosion.Avoid locations where an ignition source is present.

A drained fuel tank will, minimize the possibility of fuel leakage.

Position the equipment so the engine is level.
Tilting the machine can cause fuel or oil leakage.

Cover the engine and exhaust system to prevent from dust.
Notice A hot engine and exhaust system can ignite or melt some materials. Do not use sheet plastic as
a dust cover. A nonporous cover will trap moisture around the engine, promoting rust and corrosion.
Preparing the engine after a long term storage

Check your engine as described under maintenance

Start your engine as described under operation.
Notice: Gasoline oxidizes and deteriorates over time, causing hard starting. If the cylinders were coated
with oil during storage preparation, the engine may smoke briefly at startup. This is normal.
Storage planner
Less than 1- month

No special preparation is required.
1 to 2 months

Fill with fresh gasoline and add a gasoline conditioner.
2 months to 1 year

Fill with fresh gasoline and add a gasoline conditioner.

Drain fuel from carburetor.

Clean fuel sediment cup.
1 year or more

Drain fuel tank and carburetor.

Clean fuel sediment cup.

Remove spark plug.

Put a tablespoon of engine oil into the spark plug cylinder. Turn the engine slowly with the pull
rope to distribute the oil. Reinstall spark plug.

Change oil.
39