Texas SNOWBUSTER 1100E Manuel page 37


Mount the spark plug carefully, by hand, to avoid cross-threading.

After the spark plug seats, tighten with a spark plug wrench to compress the water. If reattaching
a used spark plug, tighten 1/8 - 1/4 turn after the spark plug seats. If installing a new spark plug,
tighten 1/2 turn after the spark plug seats.

Attach the spark plug cap.
Idle speed adjustment
How to:

Start the engine

Move the lever to the lower throttle position (turtle).

Turn the throttle adjusting screw to obtain the standard idle
speed. Standard idle speed: 1,800 rpm ± 1500 rpm
Sediment cup
The sediment cup prevents dirt and water from entering the carburetor. If the engine has not been
engaged over a period time, the sediment cup should be cleaned before use.
How to:

Turn the fuel valve to the Off position.

Remove the sediment cup using a 10 mm wrench.

Remove the o-ring and filter.

Clean each of the parts in a high flash-point solvent.

Reinstall the filter, o-ring, and sediment cup.

Tighten with 10 mm wrench to secure.

Return the fuel valve to the on position and check for leaks
Draining the carburetor

Loosen the carburetor drain screw.

Allow gasoline to drain completely into suitable container.

Retighten drain screw.
F7RTC or equivalent
NOTICE: An incorrect spark plug can cause engine damage.
Sediment cup assembly
0.70-0.80
mm
Drain Screw Drain Screw
37