SM 1619X09194 09-14_SPT77W 9/12/14 7:01 AM Page 11
LINE GUIDE
For a 0° cut, use the large notch in the foot.
For 45° bevel cuts, use the small notch (Fig.
6). The cutting guide notch will give an
approximate line of cut. Make sample cuts in
scrap lumber to verify actual line of cut. This
will be helpful because of the number of
different blade types and thicknesses
available. To ensure minimum splintering on
the good side of the material to be cut, face
the good side down.
WRENCH USAGE
Wrench provided has several functions other
than loosening/tightening the blade bolt (Fig. 7).
1. Loosening/tightening blade bolt (1/2" wrench)
2. Loosening/tightening combo oil plug/lock
button assembly (1/2" wrench)
3. Loosening/tightening brush caps (slotted
driver)
4. Loosening/tightening bevel/depth levers
when levers are over tightened or additional
tightening is needed (9/16" wrench)
5. Blade diamond arbor knock out (wedge
feature)
Storage is provided on the tool (Fig. 1A).
Wrench is fully seated when second lock detent
is engaged.
Wrench needs to be inserted
C UTION
with the correct orientation
(Fig. 8). Damage to work piece could occur if
inserted incorrectly.
1/2" WRENCH
9/16" WRENCH
WEDGE
FE TURE
SLOTTED
DRIVER
CORRECT
0° CUTS
FIG. 6
45° BEVEL
FOOT
CUTS
1
0
1
3
FIG. 8
-11-
PUSH 45° STOP
SPRING IN
DIRECTION OF
RROW FOR BEVEL
DJUSTMENTS
°
BOVE 45
45° STOP
SPRING
FIG. 7
2
4
5
INCORRECT