Programming Additional Transmitters/Channels - Stiebel Eltron IA Manuel D'utilisation Et Installation

Programming additional transmitters / channels
N O T E !
If several receivers are connected to the same feed
line, then all are simultaneously ready to program.
Max. 16 transmitters can be programmed into a
receiver (IA receiver). The radiant heater begins to
briefly light up 'at random'.
Individual channels/transmitters can now be assigned
to the respective receiver.
You can stop the flashing if you briefly push the STOP
button of a transmitter which has already been pro-
grammed.
The channel assignment/change can now be made with-
out you having to disconnect the individual receivers.
To program additional transmitters in one receiver, please pro-
ceed as follows:
1. Press the following buttons
on the programmed trans-
mitter simultaneously:
▲ button
▼ button
Programming button P (on
the back).
Press the ▲ button within the
2.
first 2 sec. of the program-
ming phase during the 100 %
heating cycle.
(New transmitter/channel)
3.
Press the ▼ button within the
first 2 sec. of the programming
phase during the 50 % heating
cycle.
(New transmitter/channel)
Programming additional transmitters / channels
The transmitter is now programmed.
- 3 1 -
Press the buttons
for approx. 3 sec-
onds. The heating
system alternates
between 100% and
50% heating power
for 2 minutes.
Heating switches
off for a short time.
Heating
switches off.