Programming The Transmitter; Programming The Transmitter/Channel - Stiebel Eltron IA Manuel D'utilisation Et Installation

Programming the transmitter/channel

Programming the transmitter/channel
!
P R E R E Q U I S I T E !
The IA receiver must be installed.
1. Disconnect the fuse – and reconnect after a few seconds.
The receiver is now in programming mode for approx. 5 minutes.
2. Stand in front of the radiant heater with the IR remote control.
3. Press the Select
button to select a
channel.
4. Briefly press the
Programming button
P (on the back) .
5. Press the ▲ button
within the first 2 sec.
of the programming
phase during the 100
% heating cycle.
6. Press the ▼ button
within the first 2 sec.
of the programming
phase during the 50 %
heating cycle.
The transmitter is now programmed.
The radiant heater switch-
es between 100 % and
50 % of its heating power
for 2 minutes.
Heating switches off for
a short time.
Heating switches off.
- 3 0 -