Hilti NURON TE 2000-22 Mode D'emploi page 14

Status
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
4 Cordless breaker
Weight without battery
Single impact energy
Ambient temperature for operation
Storage temperature
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the batteries, make sure that the product is switched off.
▶ Remove the batteries before making adjustments and before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the batteries
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 6
5.2 Inserting batteries
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the batteries, make sure that the contacts on the batteries and the contacts on the
product are free of foreign matter.
▶ Make sure that the batteries always engage correctly.
1. Charge the batteries fully before using them for the first time.
2. Push the batteries into the product until they engage with an audible click.
3. Check that the batteries are seated securely.
8 English
Meaning
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
2301753
*2301753*
TE 2000­22
17.4 kg
(38.4 lb)
38.2 J
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
21.6 V
See the end of these
operating instructions
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)