Assembling Your Stroller - Evenflo Victory Mode D'emploi

1
A
B
B
2
CLICK!
NOTE: Hardware for front wheel assembly is located
on wheel .
Turn the stroller upside down so the front of the
stroller is facing upwards, as shown.
Loosen the nut on each side so that the forks
will fit under the silver tabs
onto the forks. Ensure the silver tabs fit into the
openings on the forks as shown. Use the wrench
tool to tighten both nuts.
E
DO NOT inflate tires above the maximum
recommended inflation pressure listed on the side
of the tire. Over inflation may cause wheel and/or
C
tire to blowout and could result in serious injury.
Use manual bicycle pump to inflate tires.
WARNING
Wheel can detach and cause tip over . Pull on the
wheel to assure it is securely attached . Periodically
check wheel to assure it is securely attached .
WARNING
Care must be taken when folding or unfolding
stroller to prevent finger injury in hinge areas .
To protect flooring, place a protective covering
(cardboard, towel, small rug or blanket) beneath
the stroller during assembly.
Unlatch side frame lock
Continue holding the lock open
while unfolding the stroller.
A
Grab the parent's handle
pull upward until the stroller opens fully with an audible click.
Make sure the stroller locks in the open position.
C
. Slide the front wheel
D
FALL HAZARD

ASSEMBLING YOUR STROLLER

.
A
near the top of the canopy and
B
E
D
3